Brake Adjustment - Ducati PRO-III Manual Del Usuario

9. Brake adjustment

Brake levers
Refer to point A (see photo) to adjust the
position of the brake lever, if necessary.
A
C
Adjusting the front brake calliper
If the brake is too tight or too loose, use
the hex wrench to loosen screw (A), then
adjust the brake wire (shorten the brake wire
from the top end if it is too tight. If the wire
is too loose, pull it from the bottom end),
then tighten screw (A) again. If the wire is
too loose or too tight even after following
the first step, it may be necessary to adjust
the (fixed) brake pad by means of the wheel
located on the opposite side.
Use the hexagon wrench to move away (B)
A
(counter-clockwise) or closer (clockwise) the
brake pad (see picture).
D
Check the correct alignment between the
brake caliper and the disc. Use screws C and
D to adjust the position / alignment on the
disc, if necessary.
B
13