Assembly And Set-Up - Ducati PRO-III Manual Del Usuario

IMPORTANT
The vehicle is delivered folded and with the handlebar removed.
Method:
1. Open the kickstand
2. Pick up the handlebar, place the lever in the closed position and lower the safety ring.
3. Install the handlebar on the shaft
4. Install the hook (see photo) by approaching it to the rod, making sure that it is aligned
with the holes, then insert the screws.
5. Insert the screw on the outside into the hole located under the control panel.
6. Tighten the screws.
7. Align the plastic plate (see photo) with the second hole/profile of the control panel,
then insert and tighten the screw.
8. Charge the battery to 100%
9. Adjust the folding mechanism**
10. Adjust the braking system (chapter 9)
11. Check the pressure of the tires (44PSI)*.
*If the scooter does not reach at least 60% of the declared Km, or the maximum speed
within the first 3 months of use, it is likely that the wheels have deflated again. In this
case, it is necessary to restore the pressure as indicated (44PSI).
** If the lever is too soft when closing, tighten the front Allen screw just enough to
increase the safety grip.

6. Assembly and set-up

10