Lenco IR-2100 Manual Del Usuario página 7

All manuals and user guides at all-guides.com
Listen to the FM radio:
In order to switch the radio from Internet radio, you need to press the "Mode" key once or select
the Tuner in the menu list, the radio will then automatically tune to the nearest station; \
On the top line of the display is current station name of frequency, and the radio can display the
RDS message if the RDS is available;
106.20MHz FM
(RDS Message)
It is possible to switch between stereo and mono mode, this is helpful if you are listening to a poor
FM signal.
To switch between mono and stereo, press SELECT button, then you will see mono when you are
listening to stereo or stereo when you are listening to mono, to toggle between each mode just
press the SELECT key again.
Auto scan:
To search for a FM station, you need to press and hold 2 seconds the Tuning UP or DOWN keys,
this will start scanning UP or DOWN the frequency band. Once a station has been found, the
scanning will stop automatically. If no station is found, then the tuning will stop once it is cycled
through the entire FM band (87.5-108MHz);
Listening to Podcast:
In order to listen to Podcast, you need to select the podcast in the menu list, then you can select
your favorite podcast program.
Changing the volume:
You can change the volume by pressing the Volume Up or Down Key. The display shows the
volume bar.
Storing a radio station in a preset by the panel control:
When a radio station is playing, just hold down one of the preset buttons to store the station.
E.g. To store preset 1: press and hold the preset 1, then the LCD will show "Assigned to Preset 1"
if you want to save Radio A station to Preset 6, you should press the "5+" Key to switch the preset
1-5 to preset 6-10 station, then press the number 1 button.
Assigned to
Preset 1
Playing a preset radio station when a radio station is playing, briefly press the corresponding
preset key, e.g. if you saved Radio A to Preset 1, then just press the number 1 preset key. If you
press a preset that hasn't been allocated a station, then it will display "Preset # empty".
-6-