Uline DROP (N) TELL Manual De Instrucciones

π
DROP (N) TELL
INDICATORS
1. Mount the DROP (N) TELL indicator with either
adhesive back tape or two #6-32 screws. There is
pressure sensitive tape on the back of the indicator.
2. If mounting with adhesive back, remove the liner
from the tape and press the unit to a flat surface on
the package or on the product to be monitored.
3. The DROP (N) TELL indicator must be aligned with
arrows pointed toward the direction of the shock to
be monitored. Three units are needed to provide
complete three-dimensional readout (six directions).
(See Figure 1)
RESETTABLE INDICATOR ACTIVATION
1. Push the end of a paper clip into the small hole on
the side of the indicator until the arrow snaps back.
(See Figure 2)
: Apply only enough pressure to reset the
x y „ i
arrow and spring assembly. The arrow will snap
quickly into a covered position and a slight snap
can be heard. The indicator is now ready for use.
TYPICAL USAGE CHART
• Activation depends upon the type and the amount
of cushioning used to protect a product in transit.
Drop height will also affect activation.
CONTAINER
WEIGHT IN
POUNDS
PAGE 1 OF 3
1-800-295-5510
uline.com
Container Area in Cubic Feet
0-1
0-10
100G
11-25 100G
26-50 50G
51-100 50G
101-250
25G
250-1000 15G
Over 1000 5G
1-5 6-15 16-50
100G 50G 50G
50G 50G 25G
25G 25G 25G
25G 25G 15G
25G 15G 15G
10G 10G 10G
5G 10G 10G
Para Español, vea página 2.
Pour le français, consulter les page 3.
Figure 1
Figure 2
50+
25G
25G
25G
15G
15G
10G
10G
0521 IS-2852