Setting Up The Receiver - Alto Professional STEALTH WIRELESS Guia Del Usuario

Operation
To set up and use your Stealth Wireless, follow the steps in this chapter in order. If you are setting up
a system using multiple receivers, set up each receiver one at a time, and keep each receiver
powered on as you set up additional units.
Note: Wireless reception, range, and overall performance may vary from stated specifications
depending on your equipment and the environment where your system is installed. See the
Troubleshooting section for tips on how to improve wireless performance.

Setting Up the Receiver

1. Use the included TRS to XLR cable to connect the receiver's Output to your loudspeaker.
2. Use the included power adapter to connect the receiver's power connector to your power
source. The receiver will power on automatically.
3. Set the receiver's channel using one of the following methods:
• To automatically select an RF channel:
Press the Scan button to enter scanning mode. Scanning will begin automatically after
i.
one second. Alternatively, press the +/- buttons to scan up or down for the next
available RF channel. The channel number will flash in the Display and the RF meter will
show the current level of reception for each scanned channel in real-time.
ii. Once the receiver finds the next available channel with an acceptable RF level, it will
hold that channel and continue flashing the channel number in the display.
iii. If you need to keep scanning for a different available frequency, press the +/- buttons
while the channel number is flashing to continue scanning in that direction for the next
available channel.
Press the Scan button to select the auto-scanned frequency. The channel number in the
iv.
display will stop flashing, indicating that the selected frequency is ready to be received
from the transmitter once it has been set up. If no channel is selected after one minute,
the receiver will exit channel selection mode.
• To manually select an RF channel:
i. Press the CH button once to enter manual channel selection mode. The channel number
will flash in the Display.
ii. With the channel number flashing, press the +/- buttons to increase or decrease the
frequency and corresponding channel. The RF meter will show the current level of
reception for each channel.
iii. When an acceptable frequency is found, press the CH button to select the channel. If no
channel is selected after ten seconds, the receiver will exit channel selection mode.
7