Alto Professional STEALTH WIRELESS Guia Del Usuario página 67

NOTICE CONCERNING LASER PRODUCTS: DANGER: INVISIBLE LASER RADIATION WHEN OPEN AND INTERLOCK FAILED OR
DEFEATED. AVOID DIRECT EXPOSURE TO BEAM. USE OF CONTROLS OR ADJUSTMENTS OTHER THAN THOSE SPECIFIED
HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.
NOTICE CONCERNING FCC REGULATIONS: You are cautioned that changes or modifications not expressly approved by the part
responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures: (a) reorient or relocate the receiving antenna;
(b) move this unit; (c) increase the separation between the equipment and receiver; (d) connect the equipment into an outlet on a
circuit different from that to which the receiver is connected; (e) be sure that all cables are properly shielded, using a choke or ferrite
where appropriate; or (f) consult the dealer or an experienced radio/television technician for help.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC RF Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must
not be co-located or operating in conjunction with any other antenna or transmitter.
For Canadian models:
• This device complies with Industry Canada licence-exempt RSSs. Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
• Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain
approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should
be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
• This radio transmitter (identify the device by certification number, or model number if Category II) has been approved by Industry
Canada to operate with the antenna types listed below with the maximum permissible gain and required antenna impedance for
each antenna type indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for
that type, are strictly prohibited for use with this device.
• This unit does not exceed the Class B limits for radio noise emission from digital apparatus set out in the radio interference
regulations of the Canadian Department of Communications.
ESD/EFT Warning: This unit may contain a microcomputer for signal processing and control functions. In very rare
situations, severe interference, noise from an external source, or static electricity may cause it to lock up. In the unlikely event
that this should happen, turn off the unit, wait at least five seconds, and then turn it back on again. The pins of connectors
identified with this ESD warning symbol should not be touched.
For best audio quality, avoid using this device in a high RF-radiated environment. In an environment with radio frequency interference,
the unit may malfunction and resume normal operation after removal of the interference.
For 240-volt use in U.K., use NEMA
Double-Insulated: When servicing use only identical replacement parts.
Correct Disposal of This Product: This marking indicates that this product should not be disposed with other household wastes
throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection
systems or contact the retailer where the product was purchased. They can take this product for environmentally safe recycling.
Disposal of Batteries (if applicable):
Never dispose of any types of batteries in fire or near excessive heat or direct sunlight. Overheated batteries can rupture or explode.
•
If you are unsure of how or where to dispose of a battery, refer to your local ordinances for the proper location, method, etc.
•
Alkaline batteries & lithium button cell batteries: You can safely dispose of alkaline and lithium button cell batteries with
•
normal household waste. They do not pose a health or environmental risk during normal use or disposal. (Alkaline batteries are
composed primarily of common metals like steel, zinc, and manganese.)
Do not dispose of large amounts of alkaline or lithium button cell batteries in a group. Used batteries are often not completely
"dead." Grouping them together can bring these "live" batteries into contact with one another, creating safety risks. To avoid this,
insulate each battery with tape or other non-conductive material to ensure it does not discharge.
Proven cost-effective and environmentally safe recycling processes are not yet universally available for alkaline and lithium button
cell batteries. Some communities offer recycling or collection of these batteries. For more information, refer to your local
ordinances or contact your local government.
Lead-acid batteries: Dispose of lead-acid batteries by bringing them to an electronic waste center or recycling center, or
•
dispose of them in accordance with your local ordinances. (Rechargeable lead-acid batteries are the same type used in
automobiles and should be disposed of in a similar fashion.)
California Proposition 65 Warning: This product may contain chemicals known to the State of California to cause cancer and birth
defects or other reproductive harm. (California law requires this warning to be given to customers in the State of California.)
General Note on the Declaration of Conformity: We hereby declare that this device is in accordance
with the essential requirements of the European Directive 1999/5/EC. The full EU declaration of
conformity can be requested at the following address:
®
-style 240-volt plug. For other countries use proper plug for local outlet.
7
inMusic GmbH
Harkortstr. 12 - 32
40880 Ratingen
GERMANY