Connection Diagrams - Alto Professional STEALTH WIRELESS Guia Del Usuario

Connection Diagrams

Items not listed under
Example 1 – Mono Operation
To send mono signals through the Stealth Wireless transmitter to a single receiver:
1. Connect your mixer's main output to an input on the Stealth Wireless transmitter and connect the
receiver's output to your loudspeaker's input. Keep all mixer volume and transmitter volume
controls at their minimum settings.
2. Power on the Stealth Wireless transmitter and receiver. Set their channels to matching numbers.
See the instructions for setting up the transmitter and receiver in
3. Adjust the transmitter and receiver antennas to a vertical position for best results in transmitting
the wireless signal. If the wireless signal quality is poor, change the position of the antennas.
4. Set the transmitter to Mono and adjust the Volume control to get a strong signal without clipping.
5. Turn on your loudspeaker, adjust the output level on your mixer, and adjust the Volume control
on the transmitter to hear the audio signal. If you hear noise in the signal, change to a different
channel until a clean signal comes through. See the instructions for changing the RF frequency in
Operation for more information.
Introduction > Box Contents
Power
Transmitter
Mixer
are sold separately.
Operation
Powered Speaker
for more information.
Receiver
Power
5