Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Mounting Hole
Locations
Hole
Slot
2. Install the Lavatory
CAUTION: Risk of personal injury and product damage.
Support the lavatory during installation. The mounting slots
alone cannot support the lavatory.
CAUTION: Risk of product damage. Do not overtighten the
hardware. Overtightening may damage the lavatory or finished
wall.
Install the drain to the lavatory according to the manufacturer's
instructions.
Drill 5/32" holes in the center of each mounting hole mark.
Partially install two lag screws and washers into the inside
(bottom) holes drilled in the wall.
Hand tighten the lag screws to support the lavatory.
Verify that the lavatory is level. Adjust if needed.
Carefully tighten the lag screws. To avoid scratching the finish, do
not overtighten the screws.
If the lag screw finish becomes damaged during installation,
carefully apply touch-up paint (included) to the lag screw head as
needed. Follow the instructions on the bottle.
Connect and tighten the trap to the drain.
Run water into the lavatory and check for leaks.
1042085-2-A
Wall
Washer
Lag Screw
Lavatory
4
Kohler Co.
Tabla de contenido
