Troubleshooting; Environmental Protection - Wesco WS8512 Manual Del Usuario

operating the tool.
- Use a sweeping motion from side to side. Advance slowly
keeping the accumulated debris/leaves in front of you.
- After blowing the debris/leaves into a pile, it is easy to
dispose of the pile.
Caution! - Do not blow hard objects such as nails,
bolts, or rocks.
- Do not operate the blower near bystanders or pets.
- Use extra care when cleaning debris from stairs or other
tight areas.
- Wear safety goggles or other suitable eye protection, long
pants, and shoes.
MAINTENANCE
1. Remove the battery pack before any work on the
device.
2. Store the tool, instruction manual and accessories in
a secure, dry place. In this way you will always have
the information ready.
3. Keep the tool's air vents unclogged and clean at all
times.
4. Remove dust and dirt regularly. Cleaning is best done
with a rag or brush.
5. Never use caustic agents to clean plastic parts.
CAUTION: Do not use cleaning agents to clean
the plastic parts of the tool. A mild detergent on a
damp cloth is recommended. Water must never come into
contact with the tool.
FOR BATTERY TOOLS
The ambient temperature range for use and storage of tool
and battery is between 0 ° C and 45 ° C.
The recommended ambient temperature range for the
charging station is between 0 ° C and 40 ° C.

TROUBLESHOOTING

Problem Possible
cause
The tool Low battery
does not capacity
work
The battery
pack is not fully
inserted
The battery The battery
pack cannot pack release
be removed button is not
pressed
EN
Fault
correction
Charging the battery
Insert the battery pack
to the end
Press the battery pack
release button

ENVIRONMENTAL PROTECTION

Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities or
retailer for recycling advice.
PLUG REPLACEMENT (ONLY FOR
REWIRABLE PLUG OF UK & IRELAND)
If you need to replace the fitted plug then follow the
instructions below.
IMPORTANT
The wires in the mains lead are colored in accordance
with the following code:
Blue = Neutral
Brown = Live
As the colors of the wires in the mains lead of this
appliance may not correspond with the colored markings
identifying the terminals in your plug, proceed as follows.
The wire which is colored blue must be connected to
the terminal which is marked with N. The wire which is
colored brown must be connected to the terminal which
is marked with L.
Warning!
Never connect live or neutral wires to the earth terminal
of the plug. Only fit an approved 13ABS1363/A plug and
the correct rated fuse.
Note: If a moulded plug is fitted and has to be removed
take great care in disposing of the plug and severed cable,
it must be destroyed to prevent engaging into a socket.
Connect
Blue to N
(neutral)
Outer sleeve
clamped
Fuse
Brown L(live)
Cable grip
11