Maintenance And Cleaning - Jata electro BT797 Instrucciones De Uso

• Do not remove the jug with the food until the blade is totally
stopped and the appliance has been switched off.
• Make sure neither the appliance nor the cable are in direct
contact with hot surfaces or objects.
• Always place it on a flat surface.
• Always disconnect it from the mains when you do not use it and
before assembling / disassembling or when cleaning.
• Take all necessary precautions while handling the blade, as it is
very sharp.
• The cleaning and maintenance done by users, can not be done by
children.
• If the cable were to deteriorate it must be changed by an
Authorised Service Centre.
INSTRUCTION OF USE
• Place the jug (3) on the main body (4).
• Pour the food in the jug and place the lid on it. Make sure the blender is perfectly closed and maintain always
held while in use.
• Plug the appliance into the mains.
• Turn the speed selector (5) clockwise to the desired position (1 or 2). The blender will begin to work maintaining
the selected speed.
• It is advisable to begin at the lowest speed of the blender (position 1) to later raise the highest speed (position
2) if necessary. However, and depending on the texture of the food, you may use the highest speed from the
beginning.
• The "Pulse" position of the speed selector gives you the option to use the blender intermittently, as it will only
work while you keep the selector (5) turned to that position, and it will stop when it is released.
• This position is ideal for crushing ice. Repeatedly hold and release the selector (5) in short periods of approximately
2 seconds to get crushed ice. For it, we suggest to use little ice cubes, or you can bitted them before put them on
the blender, to avoid the "igloo" effect. This means that the crushed ice get adhered to the blender walls, and it
impede that the other ice cubes arrive to the base to be crushed.
• You may add ingredients to the jug while in use without open the lid. To do so, remove the stopper (1). Add the
ingredients into the jug and place again the stopper.
• Once you have finished, set the speed selector to its " 0" position and wait for the blade to stop turning completely
before removing the jug.

MAINTENANCE AND CLEANING

• Before you proceed to cleaning, make sure the appliance is unplugged from the mains.
• You may remove the blade following the next steps:
- Place the jug faced down and remove the base turning it until clockwise.
- Turn the base in a anticlockwise direction and remove the blade block
- Hold the blade with one hand and turn the transmission clockwise.
• The jug, the lid and the stopper may be cleaned with soap and water, never in the dish-washer, taking care to
rinse and dry them carefully afterwards.
• Clean the main body with a slightly damp cloth.
• Do not use abrasive or chemical products, such as metallic scourers, which may deteriorate the surfaces of the
appliance.
All manuals and user guides at all-guides.com
11