Instructions Of Use; Maintenance And Cleaning; Environment Protection - Jata electro BT1041 Instrucciones De Uso

• Make sure neither the appliance nor the cables are in direct
contact with hot surfaces or objects.
• Always place it on a flat surface.
• Always disconnect it from the mains when you do not use it and
before assembling / disassembling or when cleaning.
• Take all necessary precautions while handling the blade, as it is
very sharp.
• The cleaning and maintenance done by user can not be done by
children without any supervision.
• If the cable were to deteriorate it must be changed by an
Authorised Service Centre.

INSTRUCTIONS OF USE

• Place the jug (3) on the main body (4). Next turn the jug clockwise till the end to leave it correctly fixed. (Fig. A).
• Pour the food in the jug and place the lid on it. Make sure the blender is perfectly closed and maintain always
held while in use.
• Plug the appliance into the mains. The ring will light up (6). This ring will stay always on when the blender is
connected to the mains and the jug inserted.
• Turn the speed selector (5) clockwise to the desired position (1 to 5). The blender will begin to work maintaining
the selected speed.
• It is advisable to begin at the lowest speed of the blender to later raise the highest speed (position 5) if necessary.
However, and depending on the texture of the food, you may use the highest speed from the beginning.
• The position "PULSE" is ideal to crush the ice. Turn the button and release the selector repeatedly for periods of
about 2 seconds to get crushed ice. For it, we suggest to use little ice cubes, or you can bit them before put them
on the blender, to avoid the "igloo" effect. This means that the crushed ice gets adhered to the blender walls, and
it impede that the other ice cubes arrive to the base to be crushed.
• You may add ingredients to the jug while in use without open the lid. During operation of the mixer, ingredients
may be added without removing the lid. To do this, remove the stopper (1). Slowly add the ingredients through
the opening in the lid and place the cap again.
• Once you have finished, set the speed selector to its " 0" position and wait for the blade to stop turning completely
before removing the jug.

MAINTENANCE AND CLEANING

• Before you proceed to cleaning, make sure the appliance is unplugged from the mains.
• You can remove the blade for cleaning by performing the following steps:
- Place the jar upside down.
- Remove the ring (7) by turning it clockwise. Direction indicated "OPEN".
- Remove the blade block (8).
- Hold the knife with your hand and turn the transmission clockwise.
• The jar, the lid, the cap and the other components of the jar can be cleaned with soap and water, never in the
dishwasher, trying to rinse and dry them well.
• Clean the main body with a slightly damp cloth.
• Do not use abrasive or chemical products, such as metallic scourers, which may deteriorate the surfaces of the
appliance.
• Once cleaned, assembly the jar by reversing the above steps and taking the precaution that all components,
silicone ring (9) and washers are in their original position and turn the ring in the direction indicated "CLOSE".

ENVIRONMENT PROTECTION

• Dispose the appliance according to the local garbage regulations.
• Never throw it away to the rubbish. So you will help to the improvement of the environment.
9