Worx Professional WU152 Manual De Usuario página 8

Do not dispose of batteries. Return exhausted batteries
to your local collection or recycling point.
Operating instructions
Note: Before using the tool, read the instruction book carefully.
BEFORE PUTTING INTO OPERATION
• BATTERY CHARGING
A battery that is new or has not been used for a longer period does
not develop its full capacity until after several charging / discharging
cycles.
A significantly reduced working period after charging indicates that
the batteries are used and must be replaced.
• TO REMOVE OR INSTALL BATTERY PACK (See Fig.A)
Locate latches on side of battery pack and depress both sides to
release battery pack from your tool. Remove battery pack from your
tool. After recharge insert the battery pack into the battery port. A
simple push and slight pressure will be sufficient.
1 AUXILIARY HANDLE (See Fig.B) (For WU164/365/367)
Slide the handle onto the drill and rotate to the desired working
position. To clamp the auxiliary handle, rotates the handgrip
clockwise. To loosen it, rotate the handgrip anti-clockwise. Always
use the handle during operation.
2 ON/OFF SWITCH (See Fig.C)
Depress to start and release to stop your drill. The on/off switch is
fitted with a brake function which stops your chuck immediately
when you quickly release the switch.
It is also a variable speed switch that delivers higher speed and
torque with increased trigger pressure. Speed is controlled by the
amount of switch trigger depression.
8