Tabla de contenido
Idiomas disponibles
Idiomas disponibles
EN
Single Size Electric Blanket Use instructions
The appliance must be used solely with the types of control indicated
on the label.
Do not place the control unit under the pillow or between the sheets
or bed covers when the appliance is connected.
Check the appliance often for signs of wear and tear. If such signs
are found or if the appliance has been used incorrectly, contact an
authorized technical service center before continuing to use it.
People with a pacemaker are recommended not to use the appliance
all night long. The appliance can be used to warm the bed but must
be switched off and disconnected from the power supply before going
to bed.
Do not use on an adjustable bed: otherwise, verify that nor the blan-
ket or the wire can remain caught or blocked.
Do not tuck in.
This appliance is not intended for medical use inside of hospitals.
Do not use the appliance if it is wet.
Do not use the appliance to keep animals warm.
Do not use when folded or if creased.
Do not insert pins or needles.
Product description Fig. A
1. Blanket
2. Outer slots
3. Control
4. Selector
5. Light indicator
6. Cord supply
Use instructions
How to use
Do not use the electric blanket if folded, make sure is it correctly tight. Tight the electric blanket between the
mattress and fitted sheet.
The outer slots are used to hold firmly the electric blanket to mattress, so it is tight. Always cover the electric
blanket with a sheet. Completely unroll the cord supply.
Usage
Connect the two round ends of the remote control cable by carefully aligning the guidelines (Fig.B)
Turn the protection ring clockwise to secure it.
Connect and inspect if the plug is well connected with the socket
Switch on the controller.
Set the selector on the desired position:
1 – MIN. level
2 – MAX. level
The light indicator lights up.
Before going to bed turn on the electric blanket and let it heat for 30 minutes, 1 hour max.
During the night it is recommended to disconnect the control unit from the power cord before going to bed.
Set the selector on 0, the light indicator switches off, and disconnect the cord supply from the socket.
11
Tabla de contenido
