Installing The System Board - Dell PowerEdge FC830 Manual Del Propietário

Tarjeta secundaria de red
Storage controller card on page 125
Expander card on page 128
Hard drives or SSDs on page 98
Hard-drive or SSD cage on page 109
Hard drive or SSD backplane

Installing the system board

Después de trabajar en el interior de su equipo
Installing the system board
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures should be performed only by Dell
certified service technicians.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Keep the 5 mm and 6 mm Hex nut drivers, #2 Phillips screwdriver, and #2 Phillips round screwdriver ready.
4. Remove the system board.
CAUTION: No levante el conjunto de placa base sujetándola por un módulo de memoria, un procesador u otro
componente.
CAUTION: Take care not to damage the system identification button while placing the system board into the
chassis.
NOTE: You must remove the system board to replace a faulty system board.
Steps
1. Hold the system board by its edges and orient it toward the front of the chassis.
2. Align the USB connectors with the slots on the front wall of the chassis.
3. Lower the system board and install the screws to secure the system board to the chassis.
136 Instalación y extracción de componentes del sled
on page 95
on page 112
on page 136
on page 51