Machine Elements; Delivery Scope; Before Putting Into Operation - Master ICSS 300-P Instrucciones De Uso

ICSS300 P.book Seite 12 Donnerstag, 6. Dezember 2007 10:06 10

Machine Elements

1 Mains cable
2 LED operation indicator
3 Burner connection jack
4 Ground/earth connection jack
5 Mode selector switch
6 On/Off switch
7 Holder for carrying strap
8 Handle
9 Burner
10 Cleaning agent
11 Burner stand
12 Burner-connection cable
13 Ground/earth connection cable
14 Ground/earth clamp
15 Allen key
16 Pad, cleaning kit
17 Plastic tube
18 Pushbutton for fluid supply
19 Retaining spring
20 Stainless steel scraper
21 Screw
22 Graphite scraper
23 Teflon ring
24 Pad of polishing set
25 Polishing agent
26 Marking agent
27 Eroding agent
28 Handle
29 Marking felt
30 Sealing ring, round
31 Graphite scraper
32 Fastening screw
33 Screen-printing stencil

Delivery Scope

Basic kit:
– 1x Control unit
– 1x Operating instructions
– 1x Burner
– 1x Burner-connection cable
– 1x Ground/earth cable
– 1x Burner stand
– 1x Carrying strap
Cleaning kit (0984 250 901):
– 1x Scraper, narrow 90°
– 1x Scraper, standard 90°
– 1x Scraper, standard 60°
12
– 1x Scraper, narrow 60°
– 5x Pad, narrow 90°
– 5x Pad, standard 90°
– 5x Pad, standard 60°
– 5x Pad, narrow 60°
– 1x Plastic tube
– 1x Retaining spring for pad attachment
– 1x Allen key, size 2.5 mm
– 1x Cleaning agent, 100 ml
Polishing kit (0984 250 902):
– 1x Graphite scraper, standard
– 1x Graphite scraper, narrow
– 1x Teflon ring, standard
– 1x Teflon ring, narrow
– 5x Pad, standard
– 5x Pad, narrow
– 1x Polishing agent, 100 ml
Marking kit (0984 800 01) (Special accessory - not
included in delivery scope!):
– 1x Agent for marking stainless steel
– 1x Agent for eroding stainless steel
– 5x Ring seal, round
– 1x Screw, 5 x 6 mm
– 1x Handle
– 1 Graphite scraper
– 20x Marking felt
– 1x Screen-printing stencil

Before Putting into Operation

The mains voltage must correspond with the
data on the type plate of the device.
Protective functions
The device is switched off automatically in case of
thermal overload. The device automatically switches
on again as soon as the temperature is in the normal
range.
In case of short circuiting between scraper and
workpiece, the current flow is automatically discon-
nected and not re-established until after the short cir-
cuit has been corrected.