Operating Tips - Stiga TITAN 740 DC Instrucciones De Uso

5.7.1 General safety checks
Object Result
Fuel lines and No leak.
connections.
Power cables. All insulation intact.
No mechanical damage.
Exhaust system. No leakage in the connections.
All screws tightened.
Hydraulic hoses. No leakage. No damage.
Drive the machine The machine should stop.
forwards/back-
wards and release
the drive/service
brake pedal.
Test driving. No unusual vibrations.
No unusual noise.
5.7.2 Electric safety check
The safety system's function must
always be checked before use.
Status Action
The clutch-brake Attempt to
pedal not depressed. start.
PTO not activated.
The clutch-brake Attempt to
pedal not depressed. start.
PTO activated.
Engine running. The operator
PTO activated. leaves the seat.
Control for imple- Attempt to
ment lifter not in engage PTO.
floating position.
5.8 START
1. Check that PTO is disengaged.
2. Do not keep your foot on the accelerator pedal.
3. Set the throttle control to ¼ throttle.
4. Depress the brake pedal fully. The indicator
lamp (1:I4) should illuminate.
5. For cold starts at lower temperatures, the engine
should be preheated before starting. See 3.4.4.2.
Then return the ignition key and start the en-
gine.
6. The machine must never be loaded or driven di-
rectly after a cold start when the hydraulic oil is
cold.
All manuals and user guides at all-guides.com
ENGLISH
Example: At -10°C run at ¼ throttle for 18 min-
utes.
When the machine is in operation, full throttle
should always be used.
To prevent unnecessary increases in pressure in
the hydraulic system, set the throttle control to
1/4 throttle before the hydraulic PTO is en-
gaged.
5.9 POWER ASSISTED STEERING
Result
The power steering transfers the force from the
The engine
machine's hydraulic system to the steering wheel
should not
when turned. This makes the machine very easy to
start.
steer when the engine is running at full throttle.
The engine
Power steering forces reduce as the engine speed
should not
reduces.
start.

5.10 OPERATING TIPS

PTO should
disengage.
Always ensure that the correct amount of oil is in
the engine. Especially when driving on slopes.
PTO should
See 5.3.
not be able to
be engaged.
Original instructions for use
Heat the hydraulic oil by running the engine at
¼ throttle. Run it for a few minutes as shown in
the diagram below..
Be careful when driving on slopes. No
sudden starting or stopping when
moving up or down a slope. Never drive
across a slope. Move from the top down,
or from the bottom to the top.
The machine must not be driven in any
direction on slopes with a gradient
greater than 10º.
Reduce the speed on slopes and when
making sharp turns to prevent the
machine from tipping over or you
losing control.
Do not turn the steering wheel to full
lock when driving in top gear and at full
throttle. The machine can easily topple
over.
Keep hands and fingers well away from
the articulated steering joint and seat
bracket. Risk of crushing injuries.
Never drive with the engine casing
open.
EN
87