Dell PowerVault NX1950 Guia De Instalacion página 11

All manuals and user guides at all-guides.com
Figure 1-2. Two-Node Configuration
PowerVault NX1950 storage systems
6
5
PowerVault MD3000 storage array
1 NIC port A to Gb Ethernet switch
for cluster
2 NIC port B to Gb Ethernet switch for
data/management/backup (optional)
3 Gb1 and Gb2 to Gigabit Ethernet
switch(es) for data (static IP address
required for Gb1, optional for Gb2)
NOTE:
You can connect both the SAS HBA adapters on each PowerVault NX1950
storage system to one storage controller. However, this is not recommended as
there is no redundancy in this configuration. For more information regarding
the supported cabling configurations, refer to the "Cabling" section in the
Dell PowerVault MD3000 Hardware Owner's Manual.
After cabling the solution, you can turn on the server(s) and the storage
enclosure.
NOTE:
Ensure that you turn on the storage arrays before turning
on the PowerVault NX1950 storage systems.
1
4
4
5
6
Port 0 on SAS HBA
to In-0 on controller 1
Port 1 on SAS HBA
to In-0 on controller 0
DRAC port to Ethernet
switch for lights-out
management (optional)
Installation Guide
2
3
9