Baker Hughes Druck ADTS 542F Manual Del Usuario página 11

WARNING
disconnecting device.
4. To disconnect power to the test set, either:
a. Remove the power cable (5) from the front of the test set, or
b. Remove the power cable from the wall socket. The wall socket connection must remain
accessible.
3.2 External Functional Earth/Ground Terminal
An external earth/ground connection stud (6) is available as a functional earth on the front panel
providing a connection/bonding point for other equipment to be connected to the same
earth/ground connection as the test set (This is not a protective earth/ground connection).
3.3 Pneumatic Connections
No external pneumatic pressures or vacuums are required as the ADTS contains internal
pressure and vacuum pumps.
Hoses (available as orderable accessories on the datasheet) are used for connection to the
"Pitot" (Pt) (1) and "Static" (Ps) (2) output ports of the ADTS.
The "Pitot" (Pt) and "Static" (Ps) outputs can then be connected to the corresponding Pitot and
Static connectors on the aircraft or aeronautical instruments.
The maximum Pt and Ps output pressure is 2 bar absolute.
The following table details the possible connector specifications:
Mating female parts are available from Druck.
3.4 Cleaning
CAUTION
The following materials are approved cleaning agents:
Note: Equivalent alternatives may be used for listed items.
The On/Standby Switch (3) on the front of the test set is not a
Name
G1/8 Pipe Thread ISO 228 - G 1/8 B
AN3
AN4
AN6
Do not use solvents to clean this equipment.
Material
Lint-free cloth
Damp cloth
Mild detergent
Soft brush
Specification
3/8 - 24 UNJF - 3A Thread
7/16 - 20 UNJF - 3A Thread
9/16 - 18 UNJF - 3A Thread
Specification
Commercially available
-
Commercially available
Commercially available
Copyright 2014 Baker Hughes Company.
English–ADTS Safety and Installation Guide | 9