Use Of The Plasmex Filter - THERMEx PLASMEXFILTER Manual Del Usuario

32 THERMEX PLASMEx fILtER
the plasmex filter must be installed as follows:
1
Install the hood according to the requirements
contained in the installation instructions for
the hood.
NOtE: Neither an exhaust nor duct should be
installed on the hood. Also, it is extremely im-
portant that a none-return valve is NOt moun-
ted.
4
NOtE: to ensure maximum efficiency of the fil-
ter, it is recommended that the filter be placed
as close to the blowout as possible.

USE OF THE PLASMEX FILTER

the plasmex filter has been designed to remove fumes, grease and particles from the air. the plasmex filter is automatically activated when the
filter detects airflow. the filter is also self-cleaning, which means that once the filter has been installed according to requirements, there is no
need for the user to do anything in order to use the plasmex filter.
2
Place the flange on the hood and make sure the
flange is turned so the plasmex filter is posi-
tioned with a distance of at least 30 mm to the
surroundings on all sides.
NOtE: the flange can only be used on hoods
where it is necessary to ensure the minimum
distance to the surroundings.
5
connect the plasmex filter to the power supply.
NOtE: the filter must be connected directly to
230 V.
3
Place the plasmex filter on the flange.
6
Install the hood's duct and connect the hood
to the power supply as described in the instal-
lation instructions for the hood.
x1
M 535101000919022021
x1