Tabla de contenido
FIG. 5
5) Attach the Corner Brace (W) to base and side panels 1/4" from the bottom edge with #8 x 5/8" Pan
Head Screws (ZC). Insert Adjustable Glides (V) into corner brace. Hammer Tack Glides (U) into
bottom of side panels about 1" from back edge.
Hinge
FIG. 6
Q
6) With the Door (L) laying down, place a Hinge (O) in each large hole in the back of the door. Line up the
screw holes in the hinge with the predrilled holes in the door and insert #6 x 3/4" Oval Head Screws
(Q). See FIGURE 6.
Attach the Knob (X) to the door with a 1" Machine Screw (Y).
THE DOOR MAY OPEN EITHER LEFT OR RIGHT.
Decide whether you would like to have the door open to the left or right before attaching
the mounting plates. If you want the door to open to the left, attach the spacer and
mounting plate to the left side panel; to open on the right attach on the right side panel.
7) Holes are punched in each side panel to mark
the locations of the upper screws for each
Hinge Spacer (NH) and Mounting Plate (P).
Since it may be difficult to see the punches
through the spacers, we recommend that you
start a screw into each punch to make the
hole easier to see. Remove the screw then
insert through the plates and spacers. With
the long arm of the plate facing out, fasten
each set in place with two #7 x 1½" Type 17
Pan Head Screw (ZA).
PAGE 6 — 731W
All manuals and user guides at all-guides.com
U
Stain Test
O
Arm
DOOR
U
ZC
Area
FIG. 6A
Y
ZA
ZA
FIG. 7
W
V
DOOR
Side
NH
P
X
Tabla de contenido
