Whittier Wood Products 731W Manual Del Usuario página 5

J
G
FIG. 3
ATTACHING THE CROWN MOULDING AND BASE:
3) Lay the Crown Moulding (G) and Base (H) face down on a protected surface and screw Cam
Connectors (J) into the predrilled holes. See FIGURE 3. Position the Crown Moulding on the unit and
line up the cam connectors with the holes in the Top (D). Insert and tighten the Cam Housings (K).
Follow the same procedure for the Base (H). See FIGURE 3A.
FIG. 4
A
BOTTOM
EE
4) Lay unit face down on a protected surface. Measure unit from left top to bottom right
right top to bottom left
Side Panel (B) until measurements are equal. If line
See FIGURE 4.
Lay Back (F) on unit so that the predrilled holes are centered on the shelves and side panels. The
birch face should be toward inside of unit and the large hole should be below the center shelf.
Attach the back with #6 x 5/8" Philtruss Antique Brass Screws (R).
All manuals and user guides at all-guides.com
J
D
F
R
B
( / )
. Measurements should be equal. If line
G
/
is longer, tap bottom of Side panel (A).
C
FIG. 3A
R
( / )
and from
/
is longer, tap bottom of
731W — PAGE 5
H