Installation Requirements; Safety Check - Bodypoint Stayflex SH350 Instrucciones De Instalación Y Para El Usuario

INSTALLATION
Seat user in wheelchair and establish correct posture
with Pelvic Support Belt. Place Stayflex pad on chest
and drape upper straps over backrest.
Top of zipper should never rise above user's
sternum.
Rear-pull
TOP STRAPS
1. Determine desired adjustment pull directionand attach top strap to harness.
2. Adjust each shoulder strap for a comfortable fit, according to the user's shoulder width and sitting position.
Mark backrest for mountingscrews.
3. Attach to backrest using Bodypoint end-fittings and suitable fasteners.
LOWER STRAPS
Wrap lower straps around backrest without obstructing other devices on wheelchair. Mount end-fittings
between the lowest rib and the seat. Attach using suitable fasteners.
2
1
3

INSTALLATION REQUIREMENTS

1. Wheelchair with a solid backrest or strap guides set
2. Mounting screws with a minimum pullout strength
Front-pull
approximately at shoulder height (adjust up/down for
pressure distribution).
of 90kg (200lbs) (Not included in package).

SAFETY CHECK

Have user lean forward and from side
to side to check fit. Check for: 1. Comfort If rubbing neck, relocate
upper straps.
2. Position If too high or too low,
adjust lower straps.
3. Interference with other devices
Relocate straps as necessary to clear
seat tilting mechanism, armrests,
accessory pads, or feeding tubes.
en
Ø 3/16–1/4"
(5–6mm)
Cam Buckle
(optional)
Suitable for
users
up to 75kg