Idiomas disponibles
Idiomas disponibles
Attention! The fitting must be installed,
flushed and tested after the valid norms.
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin.
3. Slip the fixation piece including the washer over
the threaded pins and tighten the nuts.
4. Connect the supply pipes to the isolation valves;
cold right - hot left.
5. Connect the pull rod to the pop-up waste.
Large differences in pressure between the hot and
cold water supply must be balanced.
Operation
The mixer is activated by pulling the lever handle.
Turning to the left = cooler water,
turning to the right = warmer water.
Technical Data
This mixer series-produced with waterdim-
mer
(flow limiter)
®
Rate of flow with waterdimmer:
Rate of flow without waterdimmer:
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Hansgrohe single lever mixers can be used toge-
ther with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 1.5 bars.
6
English
If the continuous flow heater makes any problems or
there comes not enough water, the flow limiter (6a)
located behind the mousseur must be removed.
To adjust the hot water limiter on single lever mixers,
please see page 13.
No adjustment is necessary when using a continuous
flow water heater.
Spare parts (see page 3)
1
1.1 screw cover
2
3
4
5
6
7
8
9
10 locking screw for handle
11 spout cpl.
12 sealing set
Special accessories
7 l/min 3 bars
X
14l/min 3 bars
max. 10 bars
1 - 5 bars
16 bars
max. 80° C
65° C
handle
flange
nut
cartridge, assy
seal
aerator cpl.
fixing set
connection hose 450 mm
pop up rod
special tool set
(not part of delivery)
33092000
96338000
96468000
96461000
92730000
95008000
94010000
95049000
94071000
96657000
96059000
96521000
92646000
58085000
