Sony SU-LW1 Manual De Instrucciones página 8

Step 2: Adjust the position of the arm bases
(For the KLV-26HG2 and the KLV-L32M1 only)
1
Arm base A
Arm base A
Arm base A
Arm base A
Step 3: Decide on the location for installation
1
Unit: mm
100
8
(GB)
Arm base B
Arm
2
1
Arm base B
Arm
3
3
4
5
5
3
If you are going to install a KDL-L32MRX1,
a KLV-L32MRX1 or a KLV-30MR1, skip
Step 2 and go to Step 3.
2
1Remove the four (two for each arm
2Remove the four screws that secure the
Arm base B
3Remove the arm bases A and put them
1
4Secure the arm bases to the Plate Unit
Tilt adjuster
5Secure the arms to the arm bases using
4
• If you are installing a display other than
Arm base B
• When using an electric screwdriver to
Tilt adjuster
Leave spaces around the display. At
least the amount of space shown in
the diagram should be left between
the display and a ceiling or raised
portions of the wall.
Tip
Refer to the table (9 (GB)) for the display installation
100
dimensions.
bases) tilt adjusters .
arm bases to the Plate Unit.
in the slots facing inward. Put both arms
and the arm bases B on the arm bases
A.
using the four screws removed in 2.
the four tilt adjusters removed in 1.
Notes
the KLV-26HG2 or the KLV-L32M1, skip
Step 2.
tighten the screws, the torque must be
approx. 2 N m.
•