Tabla de contenido
Idiomas disponibles
Idiomas disponibles
015611
Attach the holder joint firmly along the tool, and fix them
with screws tightly.
To remove the holder joint, follow above procedure in
reverse.
NOTE:
There are three types of holders (optional
•
accessory), short holder (300ml(18.3cu.in)), long
holder
(600ml(36.6cu.in)),
(800ml(48.8cu.in)).
accordingly.
Installing rod and piston
For short holder (300ml(18.3cu.in))
A
015608
For long holder (600ml(36.6cu.in))
A
B
C
013612
and
big
Use appropriate holder joint
A
013611
For big holder (800ml(48.8cu.in))
D
holder
015612
D
015607
Insert the rod into the slit of the tool.
Attach the piston and tighten it with a screw.
To remove the rod and piston, follow the installation
procedure in reverse.
NOTICE:
The teeth on the rod must point down.
•
There are four types of pistons. Piston A and D for
•
cartridges. Piston B for film type packs. Piston C
for direct filling.
Choose appropriate piston in accordance with the
•
type of caulking material container. Improper
piston may cause leakage or tool breakage.
There are three types of rods. The rod for the
•
short holder (300ml(18.3cu.in)), rod for long holder
(600ml(36.6cu.in)),
(800ml(48.8cu.in)).
accordance with holder type.
Always keep the rod and piston clean. Adhering
•
caulk may damage the tool.
7
B
C
and
rod
for
big
Use
appropriate
holder
rod
in
Tabla de contenido
