Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Hardware Needed
1/4-20 x 1 1/4 Bolt
32
(Qty. 4)
9
1/4-20 x 1 1/2 Bolt
(Qty. 2)
14
1/4-20 x 1 3/4 Bolt
(Qty. 2)
16. Attach other end of linkages #4 to
OUTSIDE of U-support #7 with bolts
#14 and 1/8" thick Plastic Washers
#36. Then slide name panel #5 onto the
same bolts #14 on the INSIDE of U-
support #7. Secure with lock nuts #15
See Figure 8B. Tighten hardware until
snug but do not over tighten. Tubes must
pivot freely.
17. Finish attaching Name Panel #5
to U-supports #7. Secure with
Hex Bolts #9 and Locknuts
#15. Tighten nuts but be
careful not to crush tubes. See
Figure 8B.
18. Attach Bottom Board #18 to Name Panels #5, as shown in
Figure 8B, using four Bolts #32 and four Locknuts #15.
19. Prepare an area for the assembly of the second table top half. If necessary, move the first table top
half aside with the aid of a helper. Be sure to place it in a location where it won't be disturbed or
damaged. If setting on its side, be sure to place the bottom edge no less than 12 inches away form
the wall. Also be sure to place carpet or pieces of the shipping carton down to protect table top
edges. If floor is not carpeted, brace table top half with a heavy object to keep it from sliding.
15
1/4" Locknut
(Qty. 8)
36
14
Plastic Washer
1/8" Thick
(Qty. 2)
4
15
7
9
36
15
First Table Top
Figure 8B
Figure 3
Figure 3
12
CAUTION:
AT LEAST TWO ADULTS ARE NEEDED TO
MOVE TABLE HALF!
18
32
32
7
15
15
5
9
36
14
4
Tabla de contenido
