Quick Setup - Technoline WS 9114 Manual De Instrucciones

QUICK SETUP

Keep your thermometer and the wireless outdoor transmitter close to each other.
Main unit : slide open the battery cover at the back, insert 2 x AAA alkaline batteries (not included).
Pay attention to the correct polarity.
Outdoor transmitter: slide open the battery cover at the back, insert 2 x AAA alkaline batteries
(not included). Pay attention to the correct polarity. Make sure the channel switch is located at 1 position.
Your thermometer will receive temperature data from your outdoor transmitter in few seconds. Then place
your transmitter in a dry and shaded area. The transmission distance (60-meter line-of-sight) may vary on
the obstruction (roof, walls, floors, ceilings, thick trees etc.), which will effectively cut signal range in half.
Battery Replacement
Thermometer: when the LCD becomes dim or unclear, replace the batteries with new ones.
Wireless transmitter: when the low battery icon
ones.
Specifications (temperature range)
Indoor : 0°C to +50°C (display shows HH.H / LL.L if out of this range)
Outdoor : -25°C to +70°C (display shows HH.H / LL.L if out of this range)
Precautions

Do not subject the unit to excessive force or shock.

Do not expose the unit to extreme temperatures, direct sunlight, dust or humidity.

Do not immerse in water.

Avoid contact with any corrosive materials.

Do not dispose this unit in a fire as it may explode.

Do not open the inner back case or tamper with any components of this unit.
Batteries safety warnings

Use only alkaline batteries, not rechargeable batteries.

Install batteries correctly by matching the polarities (+/-).

Always replace a complete set of batteries.

Never mix used and new batteries.

Remove exhausted batteries immediately.

Remove batteries when not in use.

Do not recharge and do not dispose of batteries in fire as the batteries may explode.

Ensure batteries are stored away from metal objects as contact may cause a short circuit.
appears on the LCD, replace the batteries with new
EN2