Idiomas disponibles
Idiomas disponibles
Environmental reception effects
The clock obtains the accurate time with wireless technology. Same as all wireless devices, the reception is
maybe affected by the following circumstances:
long transmitting distance
nearby mountains and valleys
near freeway, railway, airports, high voltage cable etc.
near construction site
among tall buildings
inside concrete buildings
near electrical appliances (computers, TV's, etc) and metallic structures
inside moving vehicles
Place the clock at a location with optimal signal, i.e. close to a window and away from metal surfaces or
electrical appliances.
a.
Automatic signal reception: The automatic signal reception starts by inserting the battery. After 2 to 5
minutes the hands will be adjusted to the correct radio controlled time according to the DCF-77
reception signal. Then, the time will calibrate several times a day with the DCF-77 signal reception
signal (also independent setting of summer- and winter time).
Note: The DCF-77 reception is only available in Europe.
Alarm time setting
Turn the alarm set knob in indicated direction until the desired alarm time is set.
Turn on/ off the alarm
Turn the ON/OFF switch to the ON position, the alarm will ring with a beep alarm when the set alarm time is
reached. Turn it to the OFF position, the alarm will not ring.
Note: If the alarm is not interrupted or turned off, it stops automatically after 2 minutes and rings again after 12
hours.
Snooze alarm & light
Press the SNOOZE/LIGHT button (at the top of the case) to activate the snooze alarm after 5 minutes and
turn on the light.
Reset
If the clock shows an incorrect time or after changing the battery, press the RESET button on the case back
panel to re-start the alarm clock. The hands (second, minute, hour) are adjusting again to 12 o'clock position
and the clock enters into signal reception mode. In successful signal reception the time will be adjusted to the
correct radio controlled time according to the DCF-77 reception signal.
