Dell Precision WorkStation 530 Manual Del Usuario página 9

Upgrading the Microprocessor(s)
. NOTE: Dell recommends that only a technically knowledgeable person
perform this procedure.
CAUTION: The processor can get very hot during normal
operation. Be sure that the processor has had sufficient time to
cool before you touch it.
CAUTION: Before you perform this procedure, see "Precautionary
Measures."
NOTICE: Before disconnecting a device from the computer, wait 10 to
20 seconds after disconnecting the computer from its electrical outlet. Before
removing a component from the system board, verify that the standby power
light on the system board has turned off. To locate this light, see "System Board
Components" or "Interior Service Label"
Remove the microprocessor airflow shroud:
1
Lay the computer on its right side.
a
Open the computer cover.
b
Press down and back on the indentations at the top corners of the
c
shroud.
The top anchor tabs will disengage from the chassis anchor slots.
All manuals and user guides at all-guides.com
i
n your User's Guide .
M i cr o p ro c es s o r Re p la c e m en t
7