Duronic PS991 Manual De Instrucciones página 6

Shred Type:
Shred Width:
Shredding Capacity:
Feed Opening :
Dimension:
Weight:
Setup:
1. The shredder and wastebasket housing come pre-assembled.
2. Slide the wastebasket fully into the wastebasket housing.
3. Plug the power cord into any standard 230-volt AC outlet.
4. Press the Power Button.The Power LED should light up.
Operating the shredder :
If the wastebasket is not inserted properly into the shredder, the green ready
light will not light up and the shredder will not run. With the power cord
plugged in and the wastebasket properly in place, the green ready light will be
on. When the paper is inserted into the feed opening, the shredding process
will start automatically and stop when the paper has completed its travel
through the feed opening. The machine power button is located on the top of
the shredder. Also located on top of the shredder are two function buttons.
Their purposes are:
1. When the fwd button is pressed, the shredding process will start. However,
the forward shred cycle lasts 2 seconds. This will allow the feed opening to be
cleared in the event excess paper is left in the shredder.
2. The rev button is used to assist in the removal of a paper jam, which
reverses the shredding process prior to a completed forward cycle, thus
clearing the cutters.The reverse cycle will last for 2 seconds. This should be
Specifications
Cross-cut
4 x 28 mm
18 sheets paper, credit card, CD/DVD
220mm
396x323x653mm
17.5.kg
Operation
6