Duronic PS581 Manual De Instrucciones página 6

1. The PS581 shredder should be placed on a flat, level surface.
2. Carefully place the shredder into the upright position on a flat level
surface.
3. Be careful not to place your fingers near the cutter blades.
4. With the wastebasket removed from the shredder, place the shredder
head over the cabinet, then firmly push down on the four corners of
the shredder head to lock it into place.
5. Slide the wastebasket into the shredder cabinet. Make sure that the
wastebasket is completely inserted into the shredder and that it fits
flush with the cabinet.
6. Plug the power cord into any standard 230-Volt AC outlet which shall
be installed near the equipment and should be easily accessible.
7. Place the switch in the AUTO position. The READY LED should light up.
You are now ready to start shredding.
With the electrical cord plugged in, the switch in the AUTO position and
wastebasket properly inplace the READY LED will light up. This signals that
the shredder is now ready for use. When the paper is inserted into the
feed opening, the shredding process will start automaticaly and stop when
the paper has completed its travel through the feed opening.
The PS581 mode selection switch is located on top of the shredder. Also
located on top of the shredder is the READY LED light.
• AUTO: The shredding process will start when the paper is inserted
into the feed ioening and will continue until it has completely passed
through.
• REV: In the event of a paper jam, this reverses the shredding process
in order to assist in the removal of a paper jam. Thus clearing the
cutters.
SETUP
OPERATION
6