IMPORTANT
This article gives some protection against annoying, not harmful dusts or particles.
APPLICATIONS
Suitable for protection against non toxic dust.
FITTING INSTRUCTIONS
1. Allow headbands to hang freely below hand.
2. Cup the respirator firmly against your face with the nosepiece on the bridge of your nose.
3. Stretch and pull the headband and position below your ears.
4. To test fit for respirator without exhalation valve: Cup both hands over the respirator and inhale sharply. A
negative pressure should be felt inside respirator. If air flows around your nose, tighten and reposition the
headband for better fit.
5. Leave work area immediately and return to fresh air if (a) breathing becomes difficult, or (b) dizziness or
other distress occurs.
WARNING
1. This product does not supply oxygen. Use only in adequately ventilated areas containing sufficient oxygen
to support life. Do not use this respirator when oxygen concentration is less than 17%.
2. Do not use when concentrations of contaminants are immediately dangerous to health or life.
3. Leave work area immediately and return to fresh air if (a) breathing becomes difficult, or (b) dizziness or
other distress occurs.
IMPORTANT
Choosing the right hearing protection (DIN EN 352) is mainly dependent on the type of noise occurring and
working conditions. Comfort, fit and compatibility with other protective systems such as a protective helmet are
important factors.
APPLICATIONS
Suitable for noise of any kind
FITTING INSTRUCTION
1. The padded ear shells must cover the completely ear and it may be possible that no hair is between the
shell and the ear. To set the hearing protection, make sure that the headband is on top of your head and the
ear is completely covered of hearing protection.
2. When wearing of other protective devices, make sure that they do not hinder each other.
3. Failure to follow all instructions and restrictions on the use of these products may reduce the protective
effect and result in damage to health and serious injury.
4. A carefully designed and selected protection device is essential for the protection of health. Consult a work
hygienist or occupational safety expert before use to determine suitability for intended use.
5. Do not use in areas where there is a risk of explosion. Facial hair or beards and certain facial features may
limit the protective effect of the products. Under no circumstances change the products in any way. Protect
from direct sunlight.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
NOTES ON DUSK MASK
NOTES ON EAR DEVENDERS
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed