Idiomas disponibles
Idiomas disponibles
-Replace the brewing unit by turning it into the right posi-
tion (the outlet tube facing downwards and to the front),
insert the brewing unit into the guide grooves and push it
completely into the coffee machine.
-Push the coffee grounds container back into the
appliance and push the outlet unit into the upper posi-
tion. Close the door.
The cleaning programme is complete when the " Clea-
ning programme" display goes out.
Remove the water tank (G) and fill it with minimum 1L
fresh water.
Replace the water tank.
The coffee machine is now ready for operation again and
returns to the last selected coffee mode.
CAUTION:
Residues of descaler may cause damage to the brewing
unit in the long run!
It is imperative that you rinse the brewing unit thoroughly
after every descaling process.
Anomalies and repair
- Take the appliance to an authorised technical support
service if product is damaged or other problems arise.
Do not attempt to disassemble or repair the appliance
yourself as this may be dangerous.
- If any anomaly is detected, check the following table:
CAUSE
SOLUTION
Brewing unit
Remove the brewing
soiled.
unit and rinse it
thoroughly with
flowing water.
Brewing unit
Insert the brewing
soiled.
unit into the
appliance and close
the door.
Grinding
Set a coarse grinding
fineness is
fineness or use diffe-
set too fine or
rent, coarser coffee
coffee powder
powder.
used is too fine
Communication
If one of these
failure
messages are
displayed, switch the
device off.
Switch back on again
Input voltage
after a cooling down
error
phase of approx. 30
minutes.
If the message is
displayed again, an
Main switch
error has occurred
blocked
that may need a
technical evaluation.
Coffee
temperature is
incorrect
Brewing unit
Use the splined
is blocked
opening on the
(technical
measuring spoon to
reason).
open the back of the
brewing unit with the
splined journal
(min.3 turns)
