Service Information - Black and Decker ST7700 Manual De Instrucciones

PROBLEM
Automatic line feed does not
feed more line.
SOLUTION
detailed in figure 14. If it is,
unwind the cutting line, then
wind it back on the spool neatly
so that the lines do not cross.
• Inspect tracks at the bottom of
spool for damage. If damaged,
replace spool.
•Read the code on the back of
spool. If it reads "PA66" call
customer service for a replacement.
If it reads "ABS" this is not the issue.
• Pull the cutting line until it
protrudes approximately 5-3/8
inches (136mm) from the spool.
If insufficient cutting line is left
on the spool, install a new spool
of cutting line.
• Align the tabs on the spool cap
with the cut outs in the housing.
• Push the spool cap onto the housing
until it snaps securely into place.
• If the cutting line protrudes
beyond the trimming blade, cut
it off so that it just reaches the
blade. If the automatic line
feed still does not work or the
spool is jammed, try the
following suggestions:
• Carefully clean the spool and
housing.
• Remove the spool and check if
the lever in the spool housing can
move freely.
• Remove the spool and unwind
the cutting line, then wind it on
neatly again
Replace the spool into the housing.
PROBLEM
Overfeeding
Line unravels when cap or spool
is removed
mAINTENANCE
: CLEANING
Use only mild soap and damp cloth to clean the tool. Never let any
liquid get inside the tool; never immerse any part of the tool into a liquid.
ImPORTANT: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment should be performed by Black
& Decker service centers or other qualified service organizations,
always using identical replacement parts.
ACCESSORIES
Recommended accessories for use with your tool are available
from your local dealer or authorized service center. If you need
assistance regarding accessories, please call: 1-800-544-6986.
wARNING:
recommended for use with this tool could be hazardous.

SERVICE INfORmATION

Black & Decker offers a full network of company-owned and
authorized service locations throughout North America. All Black
& Decker Service Centers are staffed with trained personnel to
provide customers with efficient and reliable power tool service.
8
SOLUTION
• Ensure you are cutting with
the tip of the line (5.25 inches
(133.4mm) from the spool).
Use the edge guide if needed to
ensure proper space is
maintained.
• Ensure you are not
exceeding a 10° angle as
shown in figure 7A.
• Be sure to keep spool fully
seated in cap until lines are
parked in holding slots (figure
15) before removing.
The use of any accessory not