Klarstein IGNITO MAX 4 Manual Del Usuario página 35

• The cut out size must obey the indication.
1. Remove the pan supports, the burner lid
and flame spreader and carefully turn the
appliance upside down and place it on a
cushioned mat.
Take care that the Ignition devices and flame
supervision devices are not damaged in this
operation.
2. Apply the sponge provided around the edge
of the appliance.
3. Do not leave a gap in the sealing agent or
overlap the thickness.
Do not use a silicon sealant to seal the appliance
against the aperture This will make it difficult to
remove the appliance from the aperture in future,
particularly if it needs to be serviced.Do not use
a silicon sealant to seal theappliance against the
aperture.
1. Place the bracket (B) over the holes that
match the size of the screws.There are one set
of screw holes in each corner of the hob (H)
Slightly tighten a screw (C) through the
bracket (B) so that the bracket is attached to
the hob, but so that you can still adjust the
position .
2. Carefully turn the hob back over and then
gently lower it into the aperture hole that you
have cut out.
3. On the underneath of the hob, adjust the
brackets into a position that is suitable for
your worktop. Then fully tighten the screws
(C) to secure the hob into position.
(A) SEALING STRIP
(C) SCREW (B) BRACKET
EN
35