Klarstein IGNITO MAX 4 Manual Del Usuario página 32

EN
32
• Gently wipe the ignition device and flame supervision device with a well wrung-out
cloth and wipe dry with a clean cloth.
• Before placing the burners back on the top plate, make sure that the injector is not
blocked.
Re-assemble the Auxiliary, Semi-Rapid, Rapid and Triple-Crown burners as
follows
For the Triple-Crown burners:
1. Place the circle burner cap(2) and burner lid(1) on the flame spreader(3) in tu
2. Place the flame spreader(5) onto the burner cup(6) and place the burner lid(4) on
the flame spreader(5).
3. Position the flame spreader(3) onto the burner lid(4).
For the Auxiliary,Semi-rapid and Rapid:
1. Place the flame spreader ( 4 ) on to the burner cup ( 5 ) so that the ignition device
and the flame supervision device extend through their respective holes in the flame
spreader.The flame spreader must click into place correctly.
2. Position the burner lid ( 1,2,3 ) onto the flame speader ( 4 ) so that the retaining
pins fit into their respective recesses.
Warning: Danger of fire
Do not mix up the top and bottom.
The locating pins must fit exactly into the notches.
1
2
7
3
4
8
5
9
6