Sony AIWA CSD-A500 Manual De Instrucciones página 27

Tape player
The tape does not move when you press
an operation button.
• Close the tape compartment securely.
The REC z button does not function.
• Make sure the safety tab on the cassette is in
place.
The tape does not erase completely.
• Clean the erase head (see page 28).
• Replace all the batteries with new ones if
they are weak.
• The source which was recorded on a TYPE II
(high position) or TYPE IV (metal) tape
using this unit is being played. Record on
TYPE I (normal) tapes and play.
The tape does not record.
• Make sure the tape is inserted properly.
• Make sure the safety tab of the cassette is in
place.
The audio is weak.
The audio quality is poor.
• Clean the heads, pinch roller and capstan (see
page 28).
• Demagnetize the heads using a demagnetizer
(see page 28).
The sound is distorted.
• A TYPE II (high position) or TYPE IV
(metal) tape is being used. Use TYPE I
(normal) tapes only.
Timer
The timer/alarm does not operate.
• Make sure the time on the clock is correct.
• Check to see if the AC power had been cut
off.
• Make sure the "c" (timer) or "
indication is displayed.
Remote
The remote does not function.
• Replace all the batteries in the remote with
new ones if they are weak.
• Make sure that you are pointing the remote at
the remote sensor on the player.
• Remove any obstacles in the path of the
remote and the player.
• Make sure the remote sensor is not exposed
to strong light such as direct sunlight or
fluorescent lamp light.
• Move closer to the player when using the
remote.
After trying the above remedies, if you still have
problems, press OPERATE to turn off the player.
Then, while holding down xENTER, press and
hold OPERATE for about 2 seconds. If the
problem persists, please consult your nearest Aiwa
dealer.
" (alarm)
GB
27