LEGRAND C2G C2G30026 Manual Del Usuario página 7

HDMI HDBaseT + RS232 and IR over Cat Extender Box
Transmitter to Box Receiver - 4K 60Hz
Wiring
Warnings:
Before wiring, disconnect the power from all devices.
•
During wiring, connect and disconnect the cables gently.
•
Steps for device wiring:
1. Connect an HDMI source to the HDMI IN port of the transmitter.
2. Connect an HDMI display to HDMI OUT port of the receiver.
3. Connect HDBT OUT port of the transmitter to HDBT IN port of the
receiver via a single Cat 5e/6/6a/7 cable.
4. Connect additional functions options.
IR pass-through: Connect IR receiver to IR IN port of the transmitter/
•
receiver, connect IR emitter to IR OUT port of the receiver/
transmitter. Then you can control the display at transmitter side or
control the source at receiver side.
RS232 pass-through: Set the DIP switch to PASS-THROUGH position,
•
connect a RS232 enable device to RS232 port of the transmitter and
receiver respectively.
5. Connect the provided DC 18V power adapter to the receiver.
Note: With bi-directional PoC function supported, one power adapter is
needed to connect to the transmitter or receiver to power both units.
6. Power on all attached devices.
5
(us)