Makita CL072D Manual De Instrucciones página 6

Battery power lamp
1
► 1. Battery power lamp
• When the remaining battery capacity gets low, the
battery power lamp blinks.
• When the remaining battery capacity gets much
lower, the tool stops during operation and the bat-
tery power lamp lights up for about ten seconds.
At this time, remove the battery cartridge from the
tool and charge it .
NOTE:
• The time at which the battery power lamp start
blinking or lighting up depends on the tempera-
ture at work place and the battery cartridge
conditions.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Disposing of Dust
CAUTION:
• Empty the cleaner before it becomes too full, or
the suction force weakens.
• Be sure to empty out the dust inside the cleaner
itself. Failure to do so may cause the sponge
filter to be clogged or the motor to be damaged.
• Never throw away the dust stopper because it
should be used whenever either the dust bag or
the paper pack is used.
2
► 1. Front cover 2. Button
1. Push the button to open the front cover. Opening
it until a click is heard allows a positive stop at that
position.
► 1. Front cover 2. Front cover joint
NOTE:
• The cleaner is constructed in such a way that
the front cover comes off when trying to force
the front cover open at the angle of more than
90°. If the front cover comes off, insert it into the
front cover joint in place.
CAUTION:
• When closing the front cover, be careful not to
pinch your fingers.
1
► 1. Dust stopper
6 ENGLISH
1
1
2