Taurus BRUME ESSENCE Manual Del Usuario página 10

- Fill the tank with water plus the anti-lime pro-
duct, leave about 30 minutes, drain and clean
with water
- Homemade solutions are not recommended in
the decaling of this appliance, such as the use of
vinegar.
How to clean the transducer:
- Put 5-10 drops of cleaning abluent on the surfa-
ce of the transducer, wait for 2-5 minutes.
- Brush off the scale from the surface.
- Rinse the transducer with clean water.
- Never use sharp or solid objects for cleaning the
transducer
How to clean the basin unit:
- Clean the water basin with soft cloth .if there is
excess film on the surfaces, then soaks the cloth
Anomalies Causes
Power lamp off or Humidifier is not plugged into
does not work the power outlet or loose.
Power lamp is on No water in water tank
but no mist
Security switch is too loose
The mist has a A New unit
strange odour
It either has dirty water or the
water has been stagnant too
long
Power light is on, Too much water in the water but the machine basin
doesn't work.
The volume of spray Too much mineral scale in the
mist is too low water basin
Water is too dirty or water kept
too long in the tank
Abnormal noise Vibration in the water tank be-
cause the water level too low
Machine is on and unstable
surface
Spray mist is coming There are gaps between the
out of the area nozzle and water tank
around the jets.
All manuals and user guides at all-guides.com
with vinegar and repeat the process.
- If there is a film in any of the depressions along
the basin ,drop a bit of vinegar into depression
and clean it out with a brush.
- Rinse the water basin with clean water.
Anomalies and repair
- Take the appliance to an authorised technical
support service if product is damaged or other
problems arise. Do not attempt to disassemble
or repair the appliance yourself as this may be
dangerous.
- If any anomaly is detected, check the following
table:
Solutions
Connect power cord to electrical outlet and
press power button
Fill water into water tank
Tighten the switch
Take out water tank, open cover, let it stay
12 hours in cool position
Clean water tank, fill with clear water
Remove the water tank. Take a small cup and remove some of the water from the
machine's water basin. Reinsert the water
tank and make sure that it sits properly
Clean transducer
Clean water tank and refill with clean water
Fill the water tank
Move the unit to a stable flat surface
Dip the nozzle in water for a while ,clean
it with a damp cloth and put it back to the
tank.