Safety Procedures And Notes Before Switching The Machine On; Routine Inspection - Skymsen ML Manual De Instrucciones

IMPORTANT
Carefully read ALL INSTRUCTIONS of this manual before turning the machine ON.
Be sure to well understand all the information contained in this manual. If you
have any question contact your supervisor or your nearest Dealer

4.2 Safety Procedures and Notes before Switching the Machine ON

4.2.1 Danger
An electric cable or electric wire with damaged jacket or bad insulation might cause
electrical shocks as well as electrical leak. Before use, check the conditions of all wires
and cables.
4.2.2 Advices
Be sure to well understand all the information contained in this manual. Every operation
function or procedure has to be thoroughly clear.
Before using any commands (switch, buttons, lever), be sure it is the correct one. In case
of doubt, consult this manual.
4.2.3 Precautions
The electric cable has to be compatible with the power required by the machine.
Cables touching the floor or close to the machine need to be protected against short
circuits.

4.3 Routine Inspection

4.3.1 Advice
When checking the tension of the belts or chains, DO NOT insert your fingers between the
belts and the pulleys and nor between the chain and the gears.
4.3.2 Precautions
Check the motor and sliding or turning parts of the machine in case of abnormal noises.
Check the tension of the belts and chains and replace the set when belts or chains show
signs of wearing.
When checking the tension of belts or chains DO NOT insert your fingers between belts
and pulleys, nor between the chains and gears.
Check protections and safety devices to make sure they are working properly.
18