TOPDON JUMPSURGE 2000 Manual Del Usuario página 4

A guide to Safety Indicator:
Solid green The Jump Starter is ready for use.
Solid red Reverse polarity of battery clamps is detected.
The battery level of the vehicle is too low.
Press the "BOOST" Button and wait until
Flash green
the Safety Indicator becomes solid green.
Then start your vehicle within 30 seconds.
The battery of the vehicle may be totally dead.
Make sure that you have correctly connected
The indicator the clamps to the vehicle battery. Then press
doesn't light up the "BOOST" Button and wait until the Safety
Indicator becomes solid green. And then start
your vehicle within 30 seconds.
You have tried 4 jump starts within 10
Alternately flash
minutes. Please disconnect the clamps
red and green
A guide to LED Light:
Press the Power Button once to turn on the jump starter.
Press and hold the Power Button for 3 seconds to turn on the
LED Light. Then press the Power Button once separately to
toggle between Flashlight, Strobe, SOS and OFF in turn.
5
and reconnect to try again.
Recharge the Jump Starter
The product comes partially charged and needs to be fully charged
prior to use. Please charge your jump starter through the Type-C
Input port once you receive it.
Note:
Only jump start vehicles when the battery level of the jump starter
is more than 50%.
Jump Start Vehicles (12V Only)
Important:
Make sure you have turned off all of the power loads of the vehicle,
including headlights, radio, air conditioner, etc., before attempting
to jump start the vehicle.
Step 1:
Plug the blue end of jumper cable into the Jump Start Socket.
6