Idiomas disponibles
Idiomas disponibles
Installation
I nstructions
I -‐Sheet
N umber
T HX03
CENTER
BRACKET
Step 6: Remove Nerf Step and set aside. Next, slide the additional 3/8 threaded clip from the upper rectangle hole and
align with the "U" shaped mark from step 5. Make a mark through the threaded part of the clip.
Step 7: Remove clip. Use a ½" drill bit and drill out the center mark. Slide the 3/8 clip back into position so the
threaded part is aligned with the hole.
Step 8: Reapeat Step 4 with the additional upper clip. Starting with the rear Bracket, raise the Nerf step into positon and
torque the bolts to 15-20 ft./lbs. Move to the front bracket and torque bolts. Then to the center brackets and torque down
bolts. ( NOTE: There are two additional mounting points in each bracket for a 5/16 self tapper or rivet for upper impacts
situations. Self tapper and rivets not included.)
Step 9: Repeat Steps 1-8 for passenger side.
NOTE: On 2014 Quad Cab models in the rear mounting location, the hex holes are offset and only the forward mounting
hole and clip are used. If desired, the rear clip may be used by cutting a 1" hole directly above the rear hex hole, and level
with the lower edge of the upper rectangular as shown by the dotted diagrams in figure 2.
4325
H amilton
M ill
R d.
S te.
4 00
|
B uford,
G A
3 0518
|
8 00.241.7219
|
l undinternational.com
"
U "
S haped
M ark
PART
N UMBER:
3 4641334,
3 4641371,
3 4641358
PRODUCT:
T errain
H X
N erf
s tep
APPLICATION:
0 9-‐15
R AM
1 500
1 0-‐15
R AM
2 500/3500
UPPER
MOUNT
Center
m ark
