LUND Summit Ridge 2.0 Instrucciones De Instalación página 3

Insert the Bolt Plates into the channels in the bottom of the Running Board closest to the
Brackets, (Figure 9). Lift the Running Board up and guide the studs through the Brackets.
7. Attach the Running Board to the Brackets with (6) 8mm Flat Washers and (6) 8mm Nylon Lock
Nuts, (Figures 10—12).
8. Properly level and adjust the Running Board and fully tighten all hardware.
9. Repeat Steps 1—8 to install (1) Running Board on the driver side.
10. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to add a protective layer
over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish. Mild soap
may be used also to clean the Running Board.
Front
(Fig 1) Passenger side mounting locations along
bottom and back of body panel illustrated
Front
(Fig 3) Slide 8mm Clip Nut into
large hole and over small hole
Passenger/right Side Installation Pictured
(2) 8mm Clip Nuts
2015-17 CHEVY COLORADO/GMC CANYON EXT CAB
Front
(Fig 2) Remove rubber plugs from front and
center mounting locations (arrows)
(2) 8mm x 25mm Hex Bolts
(2) 8mm Lock Washers
(2) 8mm Flat Washers
Front
(Fig 4) Front and Center Bracket illustration
Page 2 of 4
SR2 RUNNING BOARD
11/28/17 (RA)