Pond Boss 52543 Manual Del Usuario página 5

Step 1. Place the spillway in the desired
location and ensure it is level. If the spillway
is resting on the perimeter of the liner and
you do not want to affix the liner to the
spillway, skip to the note before step 8.
Step 2. Pull the liner up towards the lip of
the spillway. Make sure that the liner is able
to rest freely and will not be stretched once
water is added. Carefully rinse the front and
back of the liner with water and dry. The
surface needs to be clean for a proper seal.
Mark the lip of the spillway on the liner as
shown in figure 2. If you use a white chalk
for ease of visibility reclean the area after
step 3.
Step 3. Carefully trim away the section of
liner for the spillway opening as shown in
figure 3.
Step 4. Apply a continuous 1/4 in. bead of
sealant around the frame for the face plate
(the area along the sides and under the
spillway lip). There will be some holes in this
area for screws, so make sure to go around
those as you add sealant along this area.
Step 5. Align the trimmed area of the liner
flatly across the area where sealant was
applied. Make sure that the liner rests flat
without any wrinkling or pulling.
Step 6. Insert a temporary nail into the top
hole to the right and left of the spillway
opening. Use the nails to puncture through
the liner and hold it in place.
Step 7. Add the face place on the outside of
the spillway and liner to secure the liner to
the spillway. Carefully install all screws into
the face plate. Lastly remove the temporary
nails and replace with the last two screws.
NOTE: Do no use a power drill to complete
this step.
PLEASE CALL CUSTOMER CARE BEFORE RETURNING ITEM TO STORE: 1-888-755-6750
1
2
3
4
Apply sealant
5
6
Temporary nail
7
5