Remington HC5950 Manual De Instrucciones página 5

ENGLISH
adjust to the desired cutting length following the steps below.
• With the long length comb installed onto the product and the corresponding comb
switch selected (A) the adjustment can begin. The length can now be increased or
decreased in 0.5mm increments. Also ensure that the locked button is in the unlocked
position.
• For the short length comb there are 2 comb switch settings, B will increase and decrease
the cutting length in 0.5mm increments and setting C will adjust the length in 0.1mm
increments.
Note: If a red warning light is visible through the comb when installed, this is indication
that the comb selection switch is on the wrong setting.
• Press and hold the arrow up to increase the cutting length and down to decrease it. The
comb will move to reach each setting, the lengths will change as you hold the up/down
arrow, and the setting number will appear on the digital display.
• Select the desired boost level by pressing the boost button with the lock in the
unlocked position. The display will indicate the level.
• Once the desired length and boost level are reached, lock the system using the lock
switch. The display should show a closed lock, and the current length setting and boost
level. Proceed to use the clipper
• Note: Adjustments to length and boost can be done anytime the lock switch is set to
unlock. Setting can be done with the main motor off, if the power button is pressed a
second time. To turn the main motor back on the power button needs to be pressed
again.
• Press and hold the battery icon to display the remaining battery time in minutes on the
digital display. This can be used whilst the appliance is locked.
, SWITCHING BETWEEN UNITS OF LENGTH (mm, #)
Hold the power button for 3 seconds, the display will show the change between mm and #, at
this time release the power button. The setting has been changed.
Note: If the user continues to hold the power button for 8 seconds, the system will enter reset
mode
A CAUTION
Once the digital display changes from mm to grade number, release the power button to avoid
an inadvertent restart.
NOTE: The comb must be attached to the appliance in order to use the hair length selector. To
achieve 0.4mm the comb must be removed.
, Touch Lock
• Once your desired length and motor speed is set, lock the device by sliding the switch
into the lock position.
• The appliance will not cut if the lock switch is in the unlock position.
, Before Starting The Cut
• Inspect the clipper making sure that it is free from hair and dirt.
• Seat the person so that their head is approximately at your eye level.
• Before cutting, always comb the hair so it is tangle free and dry.
All manuals and user guides at all-guides.com
5