Installation - Cameo LED GOBO SCANNER 80 Manual De Usuario

SOUND-CONTROL MODE (SOUND)
Activate the sound-control mode to control the spotlights via the built-in microphone (bass impulses). Select one of the 13 different sound
programmes (So00–So12) and set the microphone sensitivity as desired (Se00–Se99). Press the MODE button repeatedly until "ModE"
appears in the display. Now press ENTER and use the UP and DOWN buttons to select "Soun", then confirm again with ENTER. Use the
UP and DOWN buttons to select "So__" then confirm with ENTER. Now you can select the desired programme by using the UP and DOWN
buttons. Confirm by pressing ENTER. You can set the microphone sensitivity by using the UP and DOWN buttons to select "Se__", confirming
with ENTER and then setting the desired value, from 00 to 99, with the UP and DOWN buttons (00 = minimum sensitivity, 99 = maximum
sensitivity). Confirm by pressing ENTER. If no further commands are entered, the display will show the programme number after about 10
seconds.
-> ENTER -> UP/DOWN
SYSTEM SETTINGS
To adjust system settings, press the MODE button repeatedly until the display shows "Set". Confirm by pressing ENTER. You can now use
the UP and DOWN buttons to select and edit one of the following menu items.
-> ENTER ->
UP/DOWN
<- MODE
SYSTEM INFORMATION
To read out system information, press the MODE button repeatedly until "InFo" appears in the display. Confirm by pressing ENTER. You can
now use the UP and DOWN buttons to select one of the following menu items and read out the desired information:
-> ENTER ->
UP/DOWN
<- MODE

INSTALLATION

Mounting to a traverse is possible with the adjustable mounting bracket and a suitable traverse clamp (not supplied). Secure the device to
the securing lug with a suitable safety rope. Note: Overhead installation may only be carried out by qualified personnel.
All manuals and user guides at all-guides.com
-> ENTER -> UP/DOWN
-> ENTER ->
<- MODE
With this menu option you
can define
which operating mode is enabled
if the DMX signal is interrupted in
DMX operating mode.
-> ENTER ->
<- MODE
reverse the TILT
movement direction
-> ENTER ->
<- MODE
reverse the PAN
movement direction
-> ENTER ->
<- MODE
Reset to factory setting
Display the software version
-> ENTER
/
-> ENTER
Display of the
total operating time
in hours
-> ENTER -> UP/DOWN
/
-> ENTER -> UP/DOWN
/
UP/DOWN
the last DMX
command is
retained
/
UP/DOWN
UP/DOWN
/
/
UP/DOWN
-
-
-> ENTER
Blackout
-> ENTER
-> ENTER
-> ENTER
-> ENTER
<- MODE
-> ENTER
<- MODE
7