Install Custom Overlay Frame; Important - KitchenAid KBCO24LS Manual De Uso Y Cuidado

Clean Before Using
After you remove all of the packaging materials, clean the inside of
your beverage center before using it. See the cleaning instructions
in "Beverage Center Care."
Important information to know about glass shelves
and covers:
Do not clean glass shelves or covers with warm water when
they are cold. Shelves and covers may break if exposed to
sudden temperature changes or impact, such as bumping.
Tempered glass is designed to shatter into many small,
pebble-size pieces. This is normal. Glass shelves and covers
are heavy. Use both hands when removing them to avoid
dropping.

Install Custom Overlay Frame

IMPORTANT:

Create custom overlay frame according to the specifications
in the "Custom Overlay Frame" section.
KitchenAid is not responsible for the removal or addition of
molding or decorative panels that would not allow access to
the appliance for service.
Remove the Door
IMPORTANT: Do not remove the grease from the washer, top
spacer or top hinge pin. Be sure to set aside the top hinge, top
spacer and washer for later use.
1. Using a Phillips screwdriver, remove the three screws from the
top hinge. Remove the top hinge.
A. Screws (3)
B. Top hinge
C. Washer
2. Remove the three screws from the top spacer. Remove the
top spacer and washer.
6
All manuals and user guides at all-guides.com
A
B
C
D
E
D. Top spacer
E. Door
3. Open the door. Lift the front of the door up, pulling straight out
to remove as shown.
Attach the Overlay Frame
NOTE: If the overlay hooks are not installed, see "Custom Overlay
Frame" for overlay hook locations.
1. Position the overlay frame ¹⁄₂" (1.27 cm) higher than the door.
Be sure to position the overlay hooks to the pilot holes.
2. Insert the overlay hooks into the top of the holes in the door.
Push against the overlay frame to force the overlay hooks
deeper into the door. Pull the overlay frame straight down to
secure the overlay hooks to the door.
3. Using a Phillips screwdriver, attach the overlay plates to the
bottom of the overlay frame and door as shown.
A B
A. Overlay frame
B. Door
C. Overlay plates (2)
D. Round-head screws (8)
C D