Vacuum Unit Cv 20, Cv 25, Cv 35I Assembly Instructions; Fitting The Mounting Bracket; Locating The Vacuum Cleaner On The Mounting Bracket; Connecting The Machine - Nilfisk CV 10 Instrucciones De Uso

5

Vacuum unit CV 20, CV 25, CV 35i assembly instructions

Fig. 14
Fig. 14
Fig. 15
Fig. 16
Exhaust
All manuals and user guides at all-guides.com
Inlet
5.1 Fitting the wall bracket
Plan the positioning of the wall bracket so that there is plenty
of space above and below the area where the vacuum unit is
to be located. Make sure there is a minimum of 400 mm (15
in) free space below the dust container.
Mark the positions for all four screw holes with a pen or si-
milar. The diameter of the holes in the holder is 5 mm (0.19
in). Select screws and, if necessary, wall plugs suitable for
the type of wall concerned. Drill the four screw holes.
Fit the wall bracket with the large opening pointing down-
wards, see Fig. 14. Then screw the holder fi rmly
into place.
5.2 Locating the vacuum cleaner on
the wall bracket
To facilitate the procedure, fi rst remove the dust container.
Free the container by pulling both handles outwards. Then
remove the container from the machine. To mount the vacu-
um cleaner/motor chassis to the wall bracket - just lower the
chassis downwards so that the locking device of the bracket
will pass through the slot of the chassis, Fig. 15. Make sure
the corresponding bracket on the machine is held fi rmly in
place by the wall bracket.
When removing the motor chassis from the wall bracket - push
the locking device towards you so it will release the chassis
and then lift the chassis up from bracket.

5.3 Connecting the machine

The machine is connected with the fl exible suction hose
in the lower position and the exhaust pipe uppermost, Fig
16. The fl exible hose is connected to the dust inlet at the
container of the cleaner. Push the hose in to the inlet at the
cleaner until the hose locks. Press the button on the hose inlet
downwards in order to remove the suction hose. The fl exible
suction hose acts as an adapter connecting the vacuum unit
with the pipe system.
NB! This connection must not be glued in case the unit
is serviced.
Position the central vacuum cleaner so that the exhaust pipe
can be kept as short as possible, max. 10 metres (393 in).
Take the surroundings into consideration when positioning
the exhaust. For this reason, you should always fi t a muffl er.
For additional information concerning the assembly and
installation of the pipe system and low-current lead, please
refer to the separate assembly instructions supplied with the
pipe package.
Push the hose in to the inlet at the cleaner until the hose locks.
Press the button on the hose inlet downwards in order to re-
move the suction hose.
9