Cutting Tips - MaxPro MPBCO355 Manual Del Usuario

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 40
WARNING: Using the saw to cut imperfect, wet or warped material may cause kickback.
Plug the cut off saw into power source, push the lock button and pull the trigger to start the cut off disc
rotating. To stop the cut off saw, release the trigger. Releasing the trigger stops the motor and reengages
the lock button to prevent injury. The momentum of the cut off disc will keep it spinning without power
from the motor. Allow the cut off disc to come to a complete stop before making any adjustments.
Before beginning to cut, ensure the work piece is secure in the vice and that the fence and cutting angle
have been adjusted to the desired positions. When the cut off disc has reached full speed, bring the cut off
disc down onto the material to be cut. Allow the weight and pressure of the cut off disc to do the work. DO
NOT FORCE IT.
When the cut off disc has cut completely through the work piece, raise the cut off disc by the handle and
release the trigger. The momentum of the cut off disc will keep it spinning without power from the motor.
Allow the cut off disc to come to a complete stop before making any adjustments to the saw.
KEEP YOUR HANDS WAY FROM THE ROTATING CUT OFF DISC!

CUTTING TIPS

WARNING: Always secure the work piece using clamps. Never use your hands to hold the work
piece in place. An unsecured work piece could cause serious injury.
WARNING: Keep hands away from the cut off disc to avoid injury.
WARNING: Do not allow the saw to touch the work piece until the cut off disc has reached its
full speed. Applying the cut off disc to the work piece before it has reached full speed might result in loose
of control and injury.
To make an angle adjustment, make sure the tool is unplugged. Loosen the two hex bolts holding the
fence in place. Then align the fence to the desired angle and retighten the hex bolts.
TIPS TO AVOID KICKBACK
Be prepared for kickback when using the saw. Kickback may cause the saw to jump backwards, and cause
serious injury to the user.
Using the saw to cut imperfect, wet or warped material may cause kickback.
Kickback can occur when the cut off disc becomes misaligned, pinched or bound, which causes the saw to
lift up and out of the work piece, and move toward the operator. Using the tool correctly can reduce the
risk of kickback. Observe the following procedures to reduce the risk of kickback:
When the cut off disc becomes bound, or the cut begins to be interrupted, release the trigger & hold the
saw in place until the cut off disc stops moving.
When restarting a cut in the work piece, center the cut off disc in the cut, and make sure it is NOT touching
the work piece.
Do not begin the cut until the cut off disc has reached its full speed.
Applying excessive force to the tool can overload the motor, decrease the lift and increase the wear on the
tool.
Always support large pieces of material with sawhorses or clamps. Large pieces can sag under their own
weight and can cause the cut off disc to bind while making the cut.
Always use new cut off disc. Old or damaged cut off discs may cause excessive friction on the work piece,
and increase the risk of kickback.
All manuals and user guides at all-guides.com
Cut Off Saw MPBCO355 User Manual
GB
10
Tabla de contenido
loading

Tabla de contenido